WeatherGuard
Frame Installation & Finishing Recommendations
Installation:
WeatherGuard jambs must be properly shimmed. For complete instructions
refer to recommendations printed on DoorGuard.
Painting:
White Cap & Textured Embossed Frame
Surface
Preparation:
Wipe the frame thoroughly with appropriate water borne cleaner/degreaser
for PVC type products to remove dirt, grease and other residue from
the surface. Rinse the jamb off thoroughly and allow drying completely
before applying paint.
Coating:
Apply two coats of exterior enamel paint as per manufacturers technical
data and label instructions for use with PVC type products. Kelly
Moore Dura-Poxy, Sherwin Williams SuperPaint A85 Series latex enamel
and Parker Paint Speed Dri oil enamel are recommended by these manufacturers
for use with the WeatherGuard frame without priming.
NOTES:
-Do not sand or abrade the frame.
-Do not use paint thinner or other petroleum distillates to clean
the frame if a latex enamel topcoat is to be applied.
-Follow manufacturers instructions regarding dry time before re-coating.
-WeatherGuard Frames do not require painting to maintain the warranty.
Staining:
Textured Embossed Frame
It is recommended that a Codel Stain Kit be used for this purpose.
Six colors of stain are available and complete finishing instructions
are included.
Home | Codel
Doors | Product Support | Contact
Us
© 2008 Codel Entry Systems, Inc.
1510 St. Paul Ave., Tacoma, WA 98421
Phone: 253-536-9655 ~ Fax: 253-536-9662
|